[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
accessing the serial device
- Date: Thu, 10 May 2007 13:09:59 +0200
- From: Thomas.Doerfler at embedded-brains.de (Thomas Doerfler)
- Subject: accessing the serial device
it is a bit difficult to answer your question, when you do not give any
information about the board/hardware/BSP you want to use.
What kind of FPGA baords are you using/which processor and peripherals
are implemented in the FPGAs? Is it a PPC/virtex/ an Altera/NIOS? A LEONx?
When you have identified your hardware, you might also want to look into
the respective console driver of the BSP you are using.
hwulf at et-inf.fho-emden.de schrieb:
> I wanted to use the POSIX interface of RTEMS to build up
> a serial communication with two FPGA boards running RTEMS.
> What is the name of the serial interface device? Is it
> /dev/ttyS0 like it is named on linux?
> Thank you very much and kind regards,
> rtems-users mailing list
> rtems-users at rtems.com
embedded brains GmbH
Thomas Doerfler Obere Lagerstr. 30
D-82178 Puchheim Germany
Tel. : +49-89-18 90 80 79-2
Fax : +49-89-18 90 80 79-9
email: Thomas.Doerfler at embedded-brains.de
PGP public key available on request