[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
gen68360 & termios
- Date: Tue, 16 Nov 2004 08:53:57 +0100
- From: sebastian.ssmoller at gmx.net (sebastian ssmoller)
- Subject: gen68360 & termios
> Without looking at the code, does it have the mapping of attributes
> to hardware right? THis is an area of code that is seldom used by
> the original BSP developer and filled with easy details to get wrong.
> Do a simple desk check on the stop bits, parity, and baud rate
> mapping from termios to hardware in the driver.
i re-checked all the configuration settings, registers a.s.o. and i
found out that i set everything correctly except ... the
"m360_clock_rate" :( ... so the initial setting of the
console was correct somehow but any further setting/calculation
"crashed" it ...
correcting this solves all my previous probs with the console drv.
sorry for the confusion
"Perfection is achieved, not when there is nothing left to add,
but when there is nothing left to take away."
--- Antoine de St. Exupery, Wind, Sand, and Stars, 1939