[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
- Date: Fri, 17 Aug 2001 17:57:42 -0600
- From: mc68332 at yahoo.com (rwas)
- Subject: PC-104
I'm using rtems with pc104. I am rather green on rtems however. I have
successfully compiled and run
two of the netdemos and hello world. My current problem is that rtems
won't use the serial port as the
My processor board is the Jumptec MOPS/586..
My main issues currently are getting or writing a device driver for
ethernet chipset (Crystal CS8900)
and drivers for a DtoA board as well as a Synchronous Serial Interface
Eric Norum wrote:
> I apologize in advance if this is a FAQ, but is anyone out there in
> RTEMS-land using PC-104 SBC's?
> If so, with what processor? Using what BSP?
> Eric Norum eric.norum at usask.ca
> Department of Electrical Engineering Phone: (306) 966-5394
> University of Saskatchewan FAX: (306) 966-5407
> Saskatoon, Canada.
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com
- From: joel at OARcorp.com (Joel Sherrill)
- From: angelo at hunterlink.net.au (Angelo Fraietta)
- From: eric.norum at usask.ca (Eric Norum)